1. Expand the product and find the air port of the guardrail valve.
2. After the guardrail tire is blown up, during the blowing process, a part of it is blown up and then put into the water. The guardrail is put into the water in sections, and then the PE foam is fixed on the bottom cloth of the lower layer.
3. Blow air on the bottom mat of the space station climbing and the bottom mat of the slide, and then put it on the corresponding position of the bottom cloth, and then expand the upper spray painting cloth to connect with the guardrail tire and mat through the combination of non-side.
4. Place each module on the corresponding position at the bottom in turn, and combine the non-side connection corresponding to the bottom; (All are connected by combination of non-side binding ropes).
5. After the space station rock climbing and space rabbit slide are unfolded, they are placed on the corresponding position on the mat and connected with the mat.
6. Hang a water bag and counterweight on the windproof fixed nose on the guardrail, and the front part of the fixed nose is connected with the fixed anchor point on the shore by wire rope.
7. After installation, inflate each module toy and connect the air chamber with the same pressure through the air pipe.
+86-0371-85956138 sites:
+86-0371-85956138
